Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Intake manifold Gasket
#1
I have a 350SB Chevy and I'm using Model # MS90314-3 Intake Manifold Gasket. Do I need to use gasket sealer when installing?
Reply
#2
Hi Bill,

No sealer on the gaskets themselves or on the sealing surfaces.

The only places sealant should be used are the 4 corners where the end seals meet the intake side rail gaskets. Use just a dab in each spot, enough to fill the gap between the end seal and intake gasket, but no more.
Reply


Please note that new posts in this forum must be approved by a moderator before becoming visible.
[-]
Quick Reply
Message
Type your reply to this message here.

Human Verification
Please tick the checkbox that you see below. This process is used to prevent automated spam bots.

Forum Jump:


Users browsing this thread: 1 Guest(s)