Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Intake Gasket ?
#11
(06-12-2017, 01:38 PM)Support Wrote:
(06-11-2017, 04:26 AM)Guest Wrote: Hello, I am about to replace the intake manifold gaskets on a 1986 Dodge 360 engine. I have a Fel Pro MS 90109 kit on the shelf and plan to use it. I've done this before on Mopar small blocks but don't remember exactly the procedure I followed. My question is about the side gaskets in this kit. Should I use any type of sealer on these? For the end gaskets I'll probably just run a bead of Black RTV.

Thank you,
Pete

Hi Pete,

No sealer should be applied to the side rail (intake) gaskets themselves or around the ports. You can use RTV for the end seals, just don't run the bead more than about 1/4" or so up the intake gaskets to form the end seals.

Thank you!
Reply
#12
(06-12-2017, 10:56 PM)Guest Wrote: Thank you!

You're welcome, good luck with your repair!
Reply


Please note that new posts in this forum must be approved by a moderator before becoming visible.
[-]
Quick Reply
Message
Type your reply to this message here.

Image Verification
Please enter the text contained within the image into the text box below it. This process is used to prevent automated spam bots.

Forum Jump:


Users browsing this thread: 1 Guest(s)